[Big Swole]

And some more....

Originally Posted by cumminalong

The forward header will just be a 90* turn down into the turbine. For the rear header I'm using a tight 180* bend that will run just slightly over the forward header and it'll dump into the turbine. That's why I put the forward header slightly lower than the rear header and left a little space between the two of them.

Each of the collectors will have v-band on it. That way I can remove either header separately or the section going into the turbine. It'll be a 3-piece setup, that way if I need to work on or get to stuff I don't have to remove EVERYTHING.

Originally Posted by cumminalong

The parts fairy came a-knockin'.......lets make more goodies....









And this is why I had to be so tight on the tolerances.....