View Single Post
Old 06-20-2007, 11:12 AM   #9
sootman
 
sootman's Avatar

Name: sootman
Title: Banned
Status: Not Here
Join Date: May 2007
Location: A Volatile State
Member`s Gallery
Posts: 849
anything over 28000 psi constitutes failure. You were a little high, but not bad for a 12V guy. I've got a set of DON M's, extrude hone'ed and EDM'ed tips and I am going to do an unbiased inspection on the quality of them. I am having all flow test and pressure tested. I am doing this because I seem to be inheriting alot of trucks with leaking inj's and all these guys say they are DON M's. I am going to find out if it is the consumer's fault or just low quality parts. Guys the feedtubes seat in the inj bodies. if you get them mixed up, they WILL leak. Just a matter of time "when" not "maybe".
  Reply With Quote