View Single Post
Old 12-09-2017, 09:56 PM   #1407
NakeDiesel
 
NakeDiesel's Avatar

Name: NakeDiesel
Title: Smoke'n in the Mud
Status: Not Here
Join Date: Jan 2010
Location: Hominy, OK
Member`s Gallery
Posts: 1,116
Did manage to get a couple of hours out in the shop tonight, so I cut out the rear cross member that was in the way of the cage frame mounts and trimmed up the other one that would have hit the cab. Trimmed up all the foam sticking out as well on the frame.

Also bolted on the transmission and the transfer case and strapped it to the top and got some stands under the engine and the tcase in readyness to figure out a transmission mount. Need to really look at how I'm going to build the mount and have it not interfere with my traction bars. I really need to move the traction bars just inside the frame and raise the fronts higher.

Looks like the rear driveshaft will be about 24" long and the front about 56" long. Need to get good measurements so I can take the old ones in and have them modified.

Click the image to open in full size.

Click the image to open in full size.

Click the image to open in full size.

Click the image to open in full size.

Click the image to open in full size.

Click the image to open in full size.
__________________
2005 Dodge Ram 3500 2x4 QC
1999 Dodge Ram 2500 4x4 QC
Coaltrain - 1946 Dodge Power Wagon powered by a little modified 12 valve.

Thanks to my sponsors: CP-Carrillo, Air Dog, Muldoons Diesel Performance, Power Driven Diesel, Diesel Performance Converters
  Reply With Quote