Thread
:
48RE Performance Transmission Rebuild
View Single Post
04-08-2014, 03:46 PM
#
34
Big Blue24
Name:
Big Blue24
Title:
Comp Diesel Sponsor
Status:
Not Here
Join Date:
Jan 2008
Location:
Cedar City, UT
Member`s Gallery
Posts:
6,310
Transgo 48re shift kit page 5
Remove the 3/4 accumulator body, (3) T-25 screws.
Drill through with the kit supplied drill bit.
Remove the (5) T-25 screws to remove the cover plate and gain access to the 3-4 accumulator piston. Remove the stock spring (sometimes it's broke in half) and install (3) new red springs provided in the kit. It is difficult to replace the cover with the higher spring pressure from the new springs. I also replaced the teflon seals on the accumulator piston with new seals provided in the master transmission rebuild kit. These seals rarely fail, but get replaced during a major overhaul/rebuild.
Install the kit supplied plugs flush or just deeper than flush:
Finally reinstall the 3/4 accumulator assembly with the kit supplied tranfer plate sandwiched between.
__________________
95' 2wd Junker Drag Truck
1502 HP Fuel-Only 12mm P7100 Pump
SXE 472 over GTX55 116mm
OEM 12v Block
Last edited by Big Blue24; 04-08-2014 at
03:49 PM
.
Big Blue24
View Public Profile
Send a private message to Big Blue24
Find More Posts by Big Blue24