12v injector puller tool?

9712valve

9712valve

Turtle Racer
anyone sell these or know where I can buy, it's not something I need very often but when I do need it sucks having to drive an hr to go borrow it from the guy who did my tranny. I asked him where he bought it and he said it was such a long time ago he can't remeber. this works much better then pry bar which.
 
i thread a metric lug nut down on the injector then clamp a pair of vice grips to the lug nut sideways and then use a regular old pry bar leveredgged off the headbolt head right infront of each injector... pops right out and works like a charm.
 
This is the tool im talking about
injectorremovaltool.jpg
 
you guys a piece of pipe cut to a length so a lug nut screws on to a couple of threads works great. you just keep tightening the nut down on the injector nad it will just pop out works slick
 
lug nut and small pry bar, it's not hard.....

and if there c^nty like your old lady, just give it an open palmed wack
 
You must log in or register to reply here.
Back
Top