Cutting piston bowls
Getting ready to do a Reenterant delete to an engine I’m playing with.
The piston im working on has an offset bowl with a deep lip. My plan was to cut the lip straight down to the bottom radius of the bowl. Going to chuck it up in a four jaw chuck and center it to the offset bowl then cut the lip off. I’d love to post pictures, but photobucket screwed me and I haven’t taken the time to figure anything else out.
I know bowl geometry is a complicated design, so I’m not looking to totally redesign it. I just want to open the bowl up to keep from burning the lip off the piston when we run advanced timing.
Application is a 1006 perkins running a “Farm stock” class
__________________
’82 300D benz Bosch MW turned up, HX30, W/A Intercooler
MF Super 90 various odds and ends done. Farm stocker
MF 98 3-71 screaming jimmy. Needs N90's. Another farm stock
'14 Ram Anarchy EFI, G56
|