I'm all about being different . Just look at my truck.2001shrtbedcmns said:didn't even notice the 4 cylinder. Think the loss of weight will negate the loss of power?
gwhammy said:I built one using 4 inch square tubing 6 inch channel for the base and schedule 40 pipe for the turning head. If you got someone to weld it don't take long and will hold up well. The head will fit the engine stand and the one mounted permanant on a column in my shop. I did make the plate to go on the motor mount as it looked like it would hang way to far out off of the back
I had the iron but almost all of it can be got out of the short racks the steel suppliers keep on hand.
6.0 heads are not aluminum, just the rocker boxes. over 100lbs each ship weight on naked heads.Mo Smoke said:6.0l have more aluminum than a 7.3l (heads are 120lbs each) ouch....