roachie
Taco Master
Havent seemed to draw much interest in selling my truck, so that '97 12 engine I have laying around looks mighty interesting. This truck is mostly for the fun of it some sled pulls, some draging, and lots of goofing off. Heres my idea on the build shooting for 800ish, lets see what the group thinks:
'97 180 hp block (O-ring the block?)
tap for 14mm head a main studs
hd rod bolts
ISB 275 pistons (need a part number)
370 marine rods (do I need them?)
full balance the bottom end
block stiffener
Helix 3 cam
3rd gen lifters (?)
ARP rocker studs
Bilet valve retainers, keepers, bridges
pushrods (any suggestions, sources?)
thinking I'll test the silver bullet's capacity:ft:
not sure on injectors, custom II's proly
I have a line on a a big P-pump havent checked into it yes
already have .093 lines, getting crossovers
what to do about water pump at high rpm?
Mabe water injection
I would like to be able to turn 4500 to 5000 without fear, I could care less about smoke. Guessing the machine work will be done at keating in Knoxville. Thank for any input.
'97 180 hp block (O-ring the block?)
tap for 14mm head a main studs
hd rod bolts
ISB 275 pistons (need a part number)
370 marine rods (do I need them?)
full balance the bottom end
block stiffener
Helix 3 cam
3rd gen lifters (?)
ARP rocker studs
Bilet valve retainers, keepers, bridges
pushrods (any suggestions, sources?)
thinking I'll test the silver bullet's capacity:ft:
not sure on injectors, custom II's proly
I have a line on a a big P-pump havent checked into it yes
already have .093 lines, getting crossovers
what to do about water pump at high rpm?
Mabe water injection
I would like to be able to turn 4500 to 5000 without fear, I could care less about smoke. Guessing the machine work will be done at keating in Knoxville. Thank for any input.