Okay, this is the final price list, as I will be breaking them down and piecing them out as follows:
6 6.7 bare blocks, all need bored and surfaced, all are currently standard, $850 EACH.
4 6.7 cranks, all standard, bet on them needing ground, $750 each.
2 6.7 cranks, fresh ground .010-.010, one needs re-polished, it got a few water drops on it, $650 each.
4 6.7 Cylinder heads, all are not cracked on the shelfs, 2 were from very MILD burns, $400 each.
Discounts for volume buys!
However, it is full price if you wanna' be a
PITA.
On small orders of 1 or 2, I will palletize and take to a TERMINAL for the buyer. THE BUYER will be responsible for arranging shipping and providing a BOL.
MAY sell all of this as a lot, PLAN ON PICKING THEM UP IF YOU GO THIS ROUTE.
I HAVE NOTHING THAT I FEEL SHOULD BE RE-ASSEMBLED AND RUN AT STANDARD SIZES!
IF YOU GET A BLOCK AND/OR CRANK AND IT POLISHES OR HONES TO STANDARD SIZE AND IT HAS PROPER CLEARANCES, THEN LUCKY YOU!
I WILL NOT STAND BEHIND STANDARD PARTS!!!