bigstacks95
Diesel Doc
- Joined
- Jul 9, 2008
- Messages
- 2,030
I have a 20-145 I need to chop up. I have a few ideas on how I'd like to do it, but I'd like to see what you guys have rigged up for a jig or an idea on how to narrow up one of these axles. I have heard the common theme of knocking 6 inches out of the long side in order to run a short side axle in both sides.
Planning on keeping the big spindles for the hubs I'd like to run, I'd rather not have to purchase F106 spindles.
TIA :Cheer:
Planning on keeping the big spindles for the hubs I'd like to run, I'd rather not have to purchase F106 spindles.
TIA :Cheer: