CRT billet valve bodies

CRT

CRT

New member
Joined
Jan 2, 2018
Messages
103
I just made this today *1-13-18 a billet reverse manual valve body ( no trans brake ) for the 46 47 48 REs & RHs The shift pattern is
P R 1 2 3 4 no Neutral. will only start in Park. Filling with fluid will take two people, one to hold foot on brake when in gear, the other to fill trans. With or with out lock up on a switch.

Tell me what you think of no neutral.

If you must have neutral, my trans brake is the same but reverse & neutral share a detente P RN 1 2 3 4 but trans brake to back up.

Thanks for your feed back John Cope
 
Last edited:
What do you gain by having no neutral? I'd probably try filling the trans by myself by putting it in gear for a bit, add some fluid, go put it in gear again, etc. assuming it's not pumping in park.
 
I came out with this vb cause some wanted to shift 1234 on the shifter but not want the trans brake . So this is a alternative.
 
CRT said:
I came out with this vb cause some wanted to shift 1234 on the shifter but not want the trans brake . So this is a alternative.
Click to expand...

Does o.d. lock instantly when shifted to 4? Also, what do you think pricing will be and availability?
 
Yes All shifts are instant no delay. Available now. I am working on price. I can say 100s cheaper than my billet trans brake.
 
Love it. Doing great things John. What are the line pressure capabilities? Are adjustments made the same?
 
DieselheaD said:
It will lock in any gear
Click to expand...

I understand it can lock in any gear. I've spoke to John a few times and the one thing that's selling me on his vb is the o.d. lockup is instant. No 1sec delay off the switch like most that are on a switch.
 
Cflanery88 said:
Love it. Doing great things John. What are the line pressure capabilities? Are adjustments made the same?
Click to expand...

I can go to 250 psi but I keep it at 195-220 psi to keep the bellview spring from failure
 
Thanks John. I have a “Billet” Belleville spring going into my trans right now as it’s all apart for a refresh and more upgrades. I was running 200psi line pressure and plan for 225psi this time around.




Sent from my iPhone using Tapatalk
 
jasonc said:
How about with a billet bellview spring?
Click to expand...



I wouldn’t go as far as saying they are Billet either. They are just a thicker stamped spring steel. Advertised 30% larger @ .090”(mine measured .093) over the factory .069” spring, and rated for 250psi line pressure iirc.


Sent from my iPhone using Tapatalk
 
Who makes that ? I need to keep them in stock
 
Last edited:
You must log in or register to reply here.
Back
Top