47RE converter problem

I just pulled the transmission out to start a rebuild and I can not get the torque converter out of the housing. I have a triple disk in there now and I do not remember having any issue when I put it in a few years ago.



The reason I am rebuilding is I beileve the belleville spring broke, it caused the rear clutch to lock engaged (forward movement in all gears)



I was locked up in overdrive when the transmission went out.



Any help??

Sounds like u messed more stuff up ,like a bent ,broke input shaft

That is what I am beginning to think also, I can get it to spin and wobble but it will not come off

jrgaylor said:

That is what I am beginning to think also, I can get it to spin and wobble but it will not come off

Click to expand...

Twisted input shaft i bet get a bigger pry bar!!

Rig up a flat plate to go across bellhousing area. Make holes in the plate that line up with 2 of the torque converter holes. Use bolts to pull torque converter up and out of trans. U can just shim the plate away from bellhousing as torque converter starts to move forward.


Sent from my iPhone using Tapatalk