DMAXchris
sleeper worktruck
Selling my truck. Its in need of some TLC and I don't have the interest or desire to sink anymore money in it. The truck will not drive due to converter needing replaced, but it runs fine.
$12,500
06 Chevy W/T
179k miles
Built Motor with 55k - Carrillo, Mahle Race cast 16.8:1 w/reliefs, Hamilton 2.6 cam & valve springs, SoCal damper, STOCK CP3, never been over 700rwhp - Built by Caleb Baker at Blackout Performance in Mt. Pleasant, PA. I have the receipts somewhere.
Turbo - Bullseye s475 - RDL Pedestal, manifolds & up pipes, PPE Y-bridge. COMES WITH BRAND NEW BANKS INTERCOOLER
Trans - Suncoast IV built by Blackout Performance, Alto red eagles, Mike L pressure tricks, CONVERTER NEEDS REPLACED!
Injectors - 45% Extrude Hone nozzles, 4 of them were replaced with the motor build.
Body - Rockers & Cab corners are in bad shape, bed is used with holes from 5th wheel and stack, paint is decent, tailgate needs replaced, rear bumper needs replaced.
Frame - typical Northeast rust
Interior - Rubber Floors, folding center console, 4x4 on the floor, Pioneer DVD, Diamond Audio door speakers, Autometer GS Boost & Pyro, ScanGauge
It has brand new brake lines, calipers, rotors and pads. Tires are 40%. Thermostats are new. It needs all new glow plugs. I bought them 2 years ago but never cared to install them.
I'll upload some pics when I get a chance today. This thing would make the perfect sled puller for someone!
7two4-8zero9-95zero1
Thanks for looking!
$12,500
06 Chevy W/T
179k miles
Built Motor with 55k - Carrillo, Mahle Race cast 16.8:1 w/reliefs, Hamilton 2.6 cam & valve springs, SoCal damper, STOCK CP3, never been over 700rwhp - Built by Caleb Baker at Blackout Performance in Mt. Pleasant, PA. I have the receipts somewhere.
Turbo - Bullseye s475 - RDL Pedestal, manifolds & up pipes, PPE Y-bridge. COMES WITH BRAND NEW BANKS INTERCOOLER
Trans - Suncoast IV built by Blackout Performance, Alto red eagles, Mike L pressure tricks, CONVERTER NEEDS REPLACED!
Injectors - 45% Extrude Hone nozzles, 4 of them were replaced with the motor build.
Body - Rockers & Cab corners are in bad shape, bed is used with holes from 5th wheel and stack, paint is decent, tailgate needs replaced, rear bumper needs replaced.
Frame - typical Northeast rust
Interior - Rubber Floors, folding center console, 4x4 on the floor, Pioneer DVD, Diamond Audio door speakers, Autometer GS Boost & Pyro, ScanGauge
It has brand new brake lines, calipers, rotors and pads. Tires are 40%. Thermostats are new. It needs all new glow plugs. I bought them 2 years ago but never cared to install them.
I'll upload some pics when I get a chance today. This thing would make the perfect sled puller for someone!
7two4-8zero9-95zero1
Thanks for looking!
