DieselheaD
New member
I've got a complete 2012 engine, harness, and tipm.
I pulled it after it was started and ran fine, guy I got it from had been talking to beans diesel about it as a donor for a swap, afaik all it needed was power to the air bag sensor wires and it would run, right now it just cranks.
For now I'd like to make it work with the 2012 ECM/harness/injectors until I can afford the 5.9 injectors I want, and the CM849 ECM/harness swap.
I want to completely strip the harness of what I don't need, I want the bare minimum. Any help is appreciated.
I pulled it after it was started and ran fine, guy I got it from had been talking to beans diesel about it as a donor for a swap, afaik all it needed was power to the air bag sensor wires and it would run, right now it just cranks.
For now I'd like to make it work with the 2012 ECM/harness/injectors until I can afford the 5.9 injectors I want, and the CM849 ECM/harness swap.
I want to completely strip the harness of what I don't need, I want the bare minimum. Any help is appreciated.