Diprocol to EV2?

I have a set of Diprocols- Pyro,Electric fuel pressure (60#), and Boost(60#) with the really nifty wiring kit and dimmer. Will the EV2 series retrofit the plugs, thermocouple, light harness, etc? Could someone post a pic of the back side of a EV2 pyro? Please????

The plugs are not compatible, but there might be a way to make it work without too much hassle. The gauge uses an orange insulation-displacement connector, which allows you to insert the wires yourself BUT requires 18-ga TXL insulated wire to work properly. If you want to re-use existing wiring you could graft short lengths of TXL wire to the end of your old harnesses (solder & shrink wrap).

Is your fuel pressure one of the later ones with a 3-wire sensor? The sensor should look like this:


If so, then the sensor is compatible.

The thermocouple should be compatible, and you should be able to just insert the gauge-end wires into the EV2 connector.

The boost gauge is a different story - we currently only offer an electronic boost gauge in EV2, which uses the same sensor & harness as a fuel pressure gauge. If you can wait for it, we are coming out with a mechanical boost gauge in the EV2 series (hopefully ready to ship within about 6 weeks). Its electrical connection is just for the dimmer, and it is just two 1/4" male quick-connect blades on the back of the gauge.

Regards,
Michael Pliska