ADaniel4573
Member
- Joined
- Jan 2, 2022
- Messages
- 105
All right, where do I start? Towards the beginning of the year I started a thread about swapping a dt360 into my 1999 f250 with a V10, and the project kind of went cold for a little bit because I gave my cylinder head to the machine shop in February and just got it back beginning of November. So if anyone remembers that thread, this is the same one, because of the inactivity my old thread got closed so we're just going to pick up right where I left off with this new one. To anyone who is new, I have a 1992 dt360 out of a school bus that I will be p7100 swapping, upgraded pushrods and valve springs, Carson stuff for trans adapter to a 4r100 that I had rebuilt and upgraded by a local guy down here in Jacksonville North Carolina. Originally I had planned for compound turbos with the stock dt360 turbo and an s369 but I have decided to just stick to a single turbo with an s366. Just this past weekend I started the full rebuild on the dt360, I'm just doing the in frame rebuild kit not the full overhaul. So just pistons, sleeves, rings, bearings. This upcoming weekend my plan is to weld my rocker arms to support the upgraded valve springs, of course that is only if I can't find cast rocker arms for this engine. Which brings me to my first question, does anyone know if a 466 cast rocker arm work on a dt360? If it does, I know where I can get a whole set for five bucks, which will be great. It's great to finally be back on an update with this motor and I will keep all of you posted as things go on.