S467-S483 Compounds for 3rd gen 5.9
High Pressure Charger - GTS spec S467.7/83/.90 built by Chris at Midwest Turbo (has 1,000 easy miles on it)
Atmospheric Charger - S483/96/1.32 from Engineered Diesel (rebuilt 250 miles ago)
I have a set of S400 compounds/twin turbos for a 3rd gen Dodge with the Cummins 5.9. I really enjoy the setup, fun to drive, good spool, and fast… but I have some bigger turbos that are going on. This would make a great set for a hot street truck or even competition. These turbos are easily capable of over 1,000hp!
I built all of the piping for this kit and everything was TIG welded, all three charge pipes were back-purged. Intake pipes are bead rolled and the down-pipe has a slip joint on the bottom for a simple install. I designed it to be as bolt-on as possible, but it will take some time to install properly.
Includes exhaust manifold, turbos, piping, support, oil feed lines, oil drain lines, heater core coolant return line, and new A/C lines. All turbo piping is stainless- 3.5” charge pipe between turbos, 3.5” charge pipe to intercooler, 4” hot pipe between turbos. 5” down-pipe made of aluminized steel that is lava heat-shield wrapped.
Turbo support is mounted using the front engine mount bolts (kit includes longer bolts) and the heater core return line bolt. There is also a support on the down-pipe that secures to the front lifting tab of the transmission housing of a 48re trans (bolt included). When installed, these turbos are very secure.
Includes all hardware necessary for oil feed and drain lines. Oil feed lines include two fittings for the top of the oil filter housing, premade lines, and the fittings installed on the turbos. The oil drain lines include a drain pipe for each turbo (made to fit the setup), -10 fittings, -10 push-lok hose, and two press-in -10 adapter fittings for the engine block.
Exhaust manifold is a three-piece ATS T-4 manifold (kit comes with two short bolts necessary for install and new manifold gaskets). Comes with a necessary 1” Stainless Diesel spacer for the top charger and two T-4 turbine housing gaskets.
I am running shock tower deletes which are necessary for the location of the S483. This setup also requires removal of the passenger side battery, which means that you will have to run a new power cable from the alternator to either the driver side battery, or I’d suggest you run it around the front of the block to the stud on the starter to keep the engine bay clean. The other factory modification involves the A/C lines. The factory ones simply don’t fit with this kit so it comes with two new lines that require some of the factory lines to be removed and replaced by the new ones.
Asking $5500
IMG_1210.JPG
IMG_1214.JPG
IMG_1221.JPG
IMG_1226.JPG
IMG_1233.JPG
IMG_0943.JPG
IMG_0946.JPG
IMG_0948.JPG
IMG_0950.JPG
IMG_1112.JPG
IMG_1122.JPG
IMG_1147.JPG
IMG_1150.JPG