HC5 Holsets

Snedge

Snedge

Comp Diesel Sponsor
I have a couple of these here. I'll get some wheel measurements and post 'em up later. And maybe even some pictures if I can learn to do it again. 500.00 each

I also have an Ht4C that needs a comp wheel and housing. 300.00
 
Too bad I'm broke Jeff that sounds like I could build a nice set of daily driving twins with this S471!
 
joefarmer said:
Dibs on any 3.6" or bigger chargers... :)
Click to expand...


Sorry nothing yet. I think I have an 82 someplace :evil. I'll keep looking


Here is what I do have.

2-Hc5 3803015
comp ind = 3.2" or 83mm
'' Exd= 5." or 127mm
exh ind = 4.96 126mm
'' exd = 3.4" 86mm

40Cm turbine on both. Both are fair. One of the HC5 turbine housing as got all the cartriage mounting bolts broke off in it. Otherwise both could be run in the condition they are.

1- Ht4 3801919

I did not pull the exhaust housing for measurements but I can tell you it is a 26CM housing
Comp wheel is 3.3 inducer
and 5.5 exducer.
The comp wheel has minor damage on the face of the inducer.
 
Last edited:
Some misc junk

See anything in this pile you'd like ?? LOL Might be a lamp base in there someplace ??
 
Last edited:
The Sunday Bump

[ame="http://www.youtube.com/watch?v=_RLiuPRMJy8"]YouTube - Johhny Cash and Kris Kristofferson[/ame]
 
KILLER 'B' said:
How desperate are you? I know where you can get some kake!! LOL
Click to expand...

I'm listening? I'm not deperate, and...... according to my usual connection (Mr. "Kake" himself), I may have some kake in route as we speak.
So...... how much we talkin'?:poke::lolly:​
 
Bump time

[ame="http://www.youtube.com/watch?v=r1MJAyRN3Lg"]YouTube - Joe Satriani - Satch Boogie (Music Video)[/ame]




Seems I can't give these away.
 
You must log in or register to reply here.
Back
Top