valvebody requirements to run

I have a 96 47re in my commonrail and im down to the wiring. I need to know what the valvebody requires to run. I am using a full manual vb so i dont need to use a pcm. I got a pinout for the pcm plug on the vb and i know i obviously need the lockup and o/d run to switches. According to the pinout i believe i need a 5 volt feed into the number 2 pin and a ground to the number 3 pin. Do i need anything else?

I'll have to look at my wiring diagrams tomorrow when I get home, but I cut the main wiring harness about 6" from the plug to the VB and made my own harness. With a full manual VB, you only need three wires. You need a 12 volt in, and ground out the OD solenoid and the Lock up solenoid with switches of your choice. I think It was pin 6 and 7 for OD and Converter Lockup, and I don't remember at the moment what color wire the 12 volt in is.

Here is a diagram.

Thanks for the diagram but what i dont understand is why it is saying 5 volt reference where does the 12 volt feed into?

Trans Relay Output or Pin #1 is your 12V feed for the lockup/od solenoids.