If someone knows where there's a good thread to answer this question. Please point me to it. I searched and read through a bunch but couldn't make heads or tails of most of what I was reading.
My truck is an 08 F450 with the 6.4 diesel. H&S XRT PRO set on "tow". Straight exhaust with DPF delete. EGR delete with BD manifolds and up-pipes. S&B filter and intake. 153,xxx miles. Oil changed at 5k religiously.
The truck keeps throwing a P2263 code. When it does this it will build alot of boost and run like ****. Usually I park it because it runs hotter and causes blowby and just makes me nervous in general. In the past replacing the
EBP sensor has always solved the issue. But lately I replaced it and it only lasted like 3 days before the issue was back. I've put like 6 of those sensors in it now.
Recently I was told that the
EBP, the
MAP, and the Barometric sensor work together to control boost and if any of those 3 is out of whack it will make the others inaccurate.
So I replaced the
EBP, the
MAP, and the
IAT since they were both carboned up and nasty. 1 day later - issue is back. So my though is that its now narrowed down to the
baro sensor. And from what I'm reading said sensor is located inside the ECM?
If this is true is there any way to troubleshoot it and make SURE that's what it needs? With the BD up-pipes the
EBP sensor is now located directly on the pipe so I've also wondered if the heat is too much for that sensor there since it was on that mickey mouse tube from the factory.
Any help is appreciated and if there's a good thread please point me to it. I've had good luck with the truck overall and would like to keep it. But it's a work truck and I need it daily so I can't be fighting stupid issues like this. Thanks again.