New to
CompD. Hope to find some help on here with a conversion project.
Just swapped an NV5600 into a 2011 68 truck. MotorOps got us fixed up with the manual trans file with EFI Live. We got it cranking over, but the ECM will not command rail pressure. We have no engine or transmission codes present. We do have a loss of communication with the ABS module, but can tackle that issue after we get it running.
Anyone have any ideas on what I might be missing for it to not command rail?
The conversion is completely done, this is all we have left to figure out.
I appreciate your time.
Thanks!
Matt