Advertisement
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Home Who's Online Today's Posts HP Calculator CompD Gift Shop Mark Forums Read
Go Back   Competition Diesel.Com - Bringing The BEST Together > Tech Area- Dodge > Dodge Tech > 94-98 2nd Gen. 12V
Register Members List Timeslips EFI Live Library Invite Your Friends FAQ Calendar Mark Forums Read

Reply
 
Thread Tools
Old 10-26-2017, 03:51 PM   #21
Lance

Name: Lance
Title: Loner
Status: Not Here
Join Date: Nov 2007
Location: Albuquerque
Member`s Gallery
Posts: 293
So when doing O-rings, what is a good technique for putting the wire in? I saw a few posts that said tap it in with a brass or plastic mallet, but where the two ends come together, how much of a gap is too much? and is there such a thing as too little of a gap?
__________________
95 2500, 100 plate, 3800 washer mod, BHAF, Auto meter, TC lockup switch, Goerend trans, New Era 435s, water/meth, 6 inch lift, DT track bar, Irok Radial 41s with Staun beadlocks, Atlas springs, 4.10s, Detroit in rear, Lock right in the front
  Reply With Quote
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:03 PM.

 


Powered by vBulletin
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright ©2006 - 2017, CompetitionDiesel.com
all information found on this site is property of www.competitiondiesel.com