Random rambling list of commonrail parts

Mark Nixon

Mark Nixon

No Savior among the flesh
6.7 CP3, good runner, $300 SHIPPED.

5.9 CP3, good runner, $250 SHIPPED.

HE351cw, have several, all have decent clearances, $350 SHIPPED.

Injectors galore, have many 5.9s and 6.7s, all sold AS-IS (recommend testing prior to use), $60 apiece SHIPPED.

6.7 cylinder heads, have 3 on hand, ALL ARE CRACKED ON THE INTAKE, $375 apiece.

6.7 shortblocks, $1800 apiece.

G-56 transmission from a 2006, very, very lightly burned, may need sensor(s), $1800.

Several 48RE transmissions, sold as cores, 2 and 4 wheel drive, $750 each, NO CONVERTERS.

Heading to Southern Indiana and Michigan on Thursday/Friday/Saturday, so delivery on heavy parts to a limited area, including: Missouri, Iowa, Indiana, Michigan and Illinois IS available.

Reply, PM, Call or Text 402-780-5127
 
Last edited:
Made my run and ALL of my CP3s, and all commonrail injector cores are sold!

Still have all the rest of the list.

Mark.
 
Got some other junk that can ride with me to Texas:

Front and rear Iron Cross bumpers, for 2010-201?, were on a burned truck, not wavy or seriously bent, will need blasted/cleaned and re-painted, $550.

Set of four 20" by 8" black finished (painted) 6 hole factory wheels, from a 2015 2500, 1 was burned and needs the inserts and cap, the other 3 have caps and inserts, NO TIRES, $600/set.

S-467.7 turbo CORE, was on a burned truck, still spins okay, but MUST BE REBUILT, $650.

Inlet pipe and downpipe from above turbo, puts a center dump manifold onto a 4th gen 6.7 with a S-467.7 turbo, $200 for both pipes.

ATS 3-piece T-4 manifold, not cracked (that I can see), center dump, no gate, $350.

4th gen exhaust/EGR delete kit, from a 2014 Crew Cab shortbed 4wd, 5 inch exhaust complete from turbo to tip, intake & exhaust delete plates and brackets on manifold, $300.
 
Last edited:
2006 5.9 longblock, no injectors, pump or turbo, spins over freely 360*, moderate burn, very small, hairline crack on the intake shelf, $1500 or will part out.

2003 6 speed HO 5.9 longblock, light burn, NO CRACKS on the intake shelf, has injectors and turbo, needs FCA, a couple of sensors, fuel lines, wiring harness and fuel bowl to run, this is an early 6 speed engine with the machined cap rods and the APPS on the cylinder head, have all parts to "rehab" it, $2000.

Several 5.9 CR blocks that need bored/sleeved, no windows or chunked bores, $300 apiece.

1 5.9 CR crank, standard now, has 1 rusty crank journal, needs cut .010/.010 to clean, $250.

Good 5.9 CP3 injection pump, $250 SHIPPED.

Full set of 5.9 CR injection lines and rail with sensor, $125 SHIPPED.
 
Last edited:
Do you have a set of motor mount brackets for an 04. The ones that bolt to the block and then motor mounts bolt to them.
 
You must log in or register to reply here.
Back
Top