Rebuilding trans for a few reasons. Broke the 2nd gear apply lever and had a bad experience with a local trans builder. So I will be upgrading a few things have parts I have collected.
Tcs Arizona 2 piece billet input
5 pinion steel front planetary
10 rivet borg warner band
Tcs billet 4.2 lever
Superior billet low /reverse servo
Sonnax zero leak servo cover
New pump gears
New sprags
Paper and rubber gasket kit
Alto high energy rebuild kit with steels
Overdrive bearing
Will not be upgrading current torque convertor was told to be a twin disk. Was holding everything I put it through. Funds aren't there for it as it is a toy
Might be missing some things. Goal will be to upgrade the clutch counts to 5 forward 6 direct and overdrive clutch packs. I noticed when I was tearing down burnt overdrive direct steels, sloppy overdrive planetary, broken 2nd gear apply lever. I will be working on this project when I can and update. I have never been in a transmission in my life so any advice from anyone.
New pump gears installed old ones showed some wear on the lobes