Quote:
Why couldn't you have a set of gears waterjet cut then hardened if needed? The guy I know cuts within a .001 . Seen a lot of really nice stuff cut on one. I had him make a split gear for a trencher chain and add two teeth.
|
lol. This is exactly what I don't want to get into. Again, I was hoping someone would chime in saying 'here ya go'. Unfortunately, as has been the case with just about everything on this truck, I may have to be the first to give it a try. I purchased a 5.9
cr from my brother-in-law so I have all the gears except pump drive. When the engine goes back together this winter, she'll have some straight cut gears even if it does require custom waterjetting or whatever.