jakethesnake
currently operational
Hey guys, had a problem flashing a single tune in after a CSP5 was loaded on a 2006 auto. Had the CSP tune loaded on the truck for a few days, wanted to switch back to a single tune to try and track down a little issue with the CSP tune. Started flash (tune says "ok to flash") after about a minute I get the message "Flash checksum failed, please retry flash procedure". So I get a little freaked out and decide to reload the CSP tune. Flash goes fine truck starts and runs with no issue. Using the same calibration number and OS on both tunes. Has anyone seen this issue before? Any help would be greatly appreciated, I can email or post anything that would help figure out what was going on.
Thanks Jake.
Thanks Jake.