Looking for an Axle oil Seal F106 Spindles

I have a sheet metal SQHD rear end with f106 spindles.

The hubs have a seal race diameter of 4.73" and the spindle has a seal surface diameter of ~4"

So I'm look for a seal with an O.D. of 4.75" and an I.D. of 3.8-3.9"

The spindle seal diameter seems to be an oddball diameter. I could turn the hubs to accept the 4.85 O.D. seals I have but I would prefer not to if there's a seal out there already.

Anybody have any suggestions?

Did you call Randy at Proformance Pros?

Yes. Not much help. They sent me two sets of seals that didn't fit. I went out and found them on Timkens website and ordered locally. Motion industries is where I picked them up from.