Identify these rods?

N

Nathan92

New member
I bought a built 6.7 motor that was probably built 8-10 years ago, I was told it had Carrillo HD rods in it and that's not the case! for the last 3 days I've been scouring the internet trying to identify these rods with no luck. can someone identify them?

they look an awful lot like R&R rods but I don't think they are, no labeling them at all
 

Attachments

  • 329989663_645098280635279_2399628649061505906_n.jpg
    329989663_645098280635279_2399628649061505906_n.jpg
    81.6 KB · Views: 0
  • 329606484_1910978712570835_948242936641377237_n.jpg
    329606484_1910978712570835_948242936641377237_n.jpg
    90.4 KB · Views: 0
Last edited:
I’m sure you’ll have better luck with some real knowledge here than the awesome guesses you got from the experts on your Facebook post.
 
Ha you saw that? I joined comp D just to ask (I did search through 15 pages of “Cummins rods” searches before asking so nobody crucify me about the search button!)
 
Nathan92 said:
Ha you saw that? I joined comp D just to ask (I did search through 15 pages of “Cummins rods” searches before asking so nobody crucify me about the search button!)
Click to expand...

Ha yep. Joined a couple groups but I don’t respond on any of them out of respect for the dumbasses who have a field day in there.

Lots of knowledgeable guys on this site. Some of them even crack jokes from time to time. Welcome to CompD.
 
Ha thanks! did you see my other post on the firepunk page? the motor these rods came out of had a bunch of helicoils holding in the 14mm main studs, first test drive with my s472/s488 and 350% overs ripped almost every stud out of the block. so here i am trying to salvage what I can out of that motor to put in my new 6.7 short block
 
Might have made a little progress, found a picture that matches my rods pretty well, might be some older version of crowers rods?
 

Attachments

  • Capture.JPG
    Capture.JPG
    59.8 KB · Views: 0
Nathan92 said:
Ha thanks! did you see my other post on the firepunk page? the motor these rods came out of had a bunch of helicoils holding in the 14mm main studs, first test drive with my s472/s488 and 350% overs ripped almost every stud out of the block. so here i am trying to salvage what I can out of that motor to put in my new 6.7 short block
Click to expand...

Man that sucks bad. I did not see the post but I’ll check it out. Hope you can get it back together without any more grief. That setup sounds like a riot.
 
You must log in or register to reply here.
Back
Top