95 front drive shaft u joint

97rada

97rada

New member
I had a drive shaft made with 1350 joints.
bcc7ebf03e1450302084249ca0f2f52a.jpg

The front joint does not fit the yoke on the Dana 60 the 1350 is to big . For some reason I assumed that was a 1350 joint. Does anyone know what exactly it is? Or if I can get a 1350 yoke for my Dana 60. Truck is question is 95 2500
 
The factory u-joint is a 7290 series. It is an inside clip, 1 1/8" diameter cap, 2 5/8" across.

The 1350 is an outside clip, 1 3/16" diameter cap, 3 5/8" across.

1350 Dana 60 29 spline yokes are readily available.
 
BigPapa said:
The factory u-joint is a 7290 series. It is an inside clip, 1 1/8" diameter cap, 2 5/8" across.

The 1350 is an outside clip, 1 3/16" diameter cap, 3 5/8" across.

1350 Dana 60 29 spline yokes are readily available.
Click to expand...



Where is the best place to get something like that ? Also the yoke doesn't measure that much off on width. The diameter sounds spot on though. So what all is needed to swap that? Just the seal behind it ?
 
I put a d70 1410 yolk on my D60 and used the front section of a 2 piece rear drive shaft(already had 1410 on both ends and the slip portion, just have to pay for a shorten and rebalance)
 
zstroken said:
I put a d70 1410 yolk on my D60 and used the front section of a 2 piece rear drive shaft(already had 1410 on both ends and the slip portion, just have to pay for a shorten and rebalance)
Click to expand...



Although that sounds awesome, this one is a bit different. You have a source for drive line parts ?
 
You must log in or register to reply here.
Back
Top