Acert liner projection

T

Tightrope

New member
I'm having trouble with an acert. Liner projection was .0055 to .006 before new liners and pistons from IPD. New liners are .001 oversized to handle heat with 16:1 compression ratio. My liner projection is now .0082 with only a liner change. Is this going to crack a liner flange?

Sent from my SM-J327R7 using Tapatalk
 
Tightrope said:
I'm having trouble with an acert. Liner projection was .0055 to .006 before new liners and pistons from IPD. New liners are .001 oversized to handle heat with 16:1 compression ratio. My liner projection is now .0082 with only a liner change. Is this going to crack a liner flange?

Sent from my SM-J327R7 using Tapatalk
Click to expand...



You might want to measure again. Cat and IPD flanges are the same thickness. The “oversized” liners just have a .001 bigger bore. But if you do have .008 you can bet you will crack a flange.
 
You must log in or register to reply here.
Back
Top