Another Oil feed line question...

cummins2001

New member

• Feb 16, 2009

• #1

I have a quick question and I feel preety stupid asking but I'm not trying to spin my pump dry. My question is, can I just swap this plug out to the right side of the pump and put my flared fitting here for my feed line, If this works fine I'm not gonna grind my head or modify a banjo bolt fitting. Thanks in advanced !- Ethan

 

GOT-Torque

is

• Feb 19, 2009

• #2

Yes you can swap your oil inlet fitting to the outside of your pump, and swap the plug to the inside. However, the outside hole doesn't have a restriction hole inside it to reduce oil flow and can cause gov. problems with the overfilling of oil.

You need an oil inlet fitting with an oil restriction hole in it...

 

kxhonda

New member

• Feb 19, 2009

• #3

I will be using this port as well. What size restriction? I thought I heard it was 5/64?

 

R

Rods

Turbo Crasher

• Feb 19, 2009

• #4

I used a 75ths drill bit, look inside the orignal hole its pretty small just go by that

 

Warpig

12V killer

• Feb 19, 2009

• #5

I believe the one Haisley sells is .076

 

GOT-Torque

is

• Feb 20, 2009

• #6

I use a 0.078" hole...