Primer Gray P-Pump 1st Gen Build

So this is just a bracket the heater mounds to? And the bracket bolts between the lift pump and block.
Couldn’t one just run without that spacer? Or does this cause clearance issues?
 
Red Sleeper said:
So this is just a bracket the heater mounds to? And the bracket bolts between the lift pump and block.
Couldn’t one just run without that spacer? Or does this cause clearance issues?
Click to expand...

Yep. Without the bracket/spacer the piston travel will max out. That's why the lift pump i installed first cracked.
 
I’m working on getting the locker into the rear end. Then I’ll put in the new radiator.

1_EF2_BCC2_A508_49_C1_9_E17_48_F6_C0393697.jpg

222_E72_C7_C227_450_E_85_A5_BF242_B77_CC81.jpg

BF838_F3_F_69_A0_4_CAE_A133_4_DDBD9021_DFC.jpg

D1_C06_BFB_2_FA2_456_B_9_F63_ABBC5_CAB70_DB.jpg
 
Go to their website and they have a measurement form you can fill out, they'll make you a set. Or just call, I bet they have 1st gen measurements already.
 
You must log in or register to reply here.
Back
Top