Rogue Diesel
New member
Does anyone know the fuel rail transducer voltage to psi out put for a 6.7 common rail?
The rail pressure sending unit is 5Vdc and it measures linear. So, output would be the following:
Example:
.05v = 0PSI or .05v = 0Mps
0 psi = 0.5v
5800 psi = 1.4v (idle)
26700 psi = 4.56v (max reading on transducer before saturation)
(The information above is the output for a 5.9 common rail).
I know that the sensor transducer is essential just producing volts and when you install a gauge, it converts it into PSI.
Thanks guys!
The rail pressure sending unit is 5Vdc and it measures linear. So, output would be the following:
Example:
.05v = 0PSI or .05v = 0Mps
0 psi = 0.5v
5800 psi = 1.4v (idle)
26700 psi = 4.56v (max reading on transducer before saturation)
(The information above is the output for a 5.9 common rail).
I know that the sensor transducer is essential just producing volts and when you install a gauge, it converts it into PSI.
Thanks guys!