building traction bar mounts
I know this topic has been beat to death in the sticky topic, but i was looking for some pics on how you guys built your front frame mounts for your traction bars. I am going to build my own and plan on bolting to the frame (but not opposed to welding it to the frame) and also boxing it in a little bit. Looking for some well built ideas for sled pulling use. Thanks in advance guys!
__________________
S&B CAI, MBRP intercooler tubes, PPE manifolds and up-pipes, profab turbo horn, MBRP downpipe, 5" straight exhaust, 10mm cp3, Fass 150 lift pump, 60% over injectors, studs, Custom traction bars, G2 tie rods, kryptonite center link, built trans & T-case
|