4th gen 2wd mega cab on 20s

I've been thinking about upgrading my wheels and tires. I found the style of wheels I'm going with but I'm not sure what widths to go with. Not sure if I should go 20x9 all the way around, or 20x9 on the front and 20x10 or 20x12. Give it a staggered look.

Wondering if any one else has done this or can find some pics. I've had trouble finding any on google.
The truck is a 2016 mega cab 2500 2wd g56.


Sent from my iPhone using Tapatalk Pro

I was considering a larger tire for the rear, but lacking the ability to rotate was a pretty big downer.

Are you trying to go with 35s or a smaller tire? For 35s I wouldn't go wider than 9 unless you want to trim a bunch.

I want to run the same height tires, I just considered staggering them. I doubt I'm going to do that. I'm running 20x12s with 33x1250s on my wife's CCSB 4x4 and it's hard as hell to keep clean. I'll probably just put 20x9sor 20x10s all the way around.


Sent from my iPhone using Tapatalk Pro

I ran 305/55R20 on 8.5" for a while and they were a bit too tucked. Bumped it to a 9 wide, 0mm offset on a 35" and they look much better now.

The 20x9s I'm looking at are +12 with a 5.5 off spec. Should kick out around 1.5" I think. Most likely barely noticeable.


Sent from my iPhone using Tapatalk Pro

If you don't go any bigger then a 33" you should be ok on clearance as long as it is not leveled then you will need to get some control arms to push it forward a hair. But I have 10 wide and it makes my tires look a lot wider then my brothers and he has 9" wide. We both run the 305/55R20 Nitto Terra G2.