Cummins front/rear cover alignment tool

AHall

AHall

Hobbyist
Installing front and rear seals can be a pain sometimes if the housing isn't aligned perfect. We had these made for the shop. I was thinking of having a run of these made. Any engine builders have interest in needing a set?

3E36AD34-08D8-44D2-8DDD-14654ECB71C2_zps3qoqgeik.jpg


205D5E8F-5CCB-48BF-A759-CA8D5E3D02BE_zpsbvvrknxo.jpg


0AF9CC3D-A1C3-4993-B935-F1C98300DB2C_zpsy2zgtceo.jpg
 
Price will depend on how many people interested. Also need to talk to a mod if this single run will require a forum vendor setup.
 
AHall said:
Price will depend on how many people interested. Also need to talk to a mod if this single run will require a forum vendor setup.
Click to expand...


If selling them at cost, I would think that would be a great thing!
 
We just talked about these in a thread a while back. I got one from Quad 4x4. It's so awesome to drive the huge rear main seal in 30 seconds and know it's square. Quad's installer is expensive, but it's stepped on the inside so it will work with speedy sleeves


Sent from my iPhone using Tapatalk
 
Seems like there is quite a bit of interest. I'll get with the machinist and report back. I'm not looking to make money on these. They are quite pricey already.
 
You must log in or register to reply here.
Back
Top