Catch can pics

I smell a section of exhaust tubing, capped on both ends with flat discs, add fittings, breathers & drain valves to taste. (at least that's what's going on my not-so pretty truck)
 
i used a 3 gallon moon tank and welded fittings for the vents and it drains back into the side of the block
ed
 
I'll get a pic of mine later. It's a small aluminum can Hellmann made for me...has a pair of 3/4" hose inlets then drains back to the factory block place. Has a 1" hose out the top to vent the fumes just like stock.
 
bc9806db.jpg

a966825a.jpg

15bda37b.jpg


This was free just my time because i had these parts in the garage. 2" exhaust pipe, i welded a nut to the bottom then used an injector tube rubber o ring on a nut to drain it. I welded 3 nuts to a plate then drilled them out to fit on the battery hold down bolt.
 
I made mine from a bit of scrap 4" aluminum tubing. The picture is pretty horrible, but you get the picture.
 

Attachments

  • 2012-05-14-21.20.52.jpg
    2012-05-14-21.20.52.jpg
    38.8 KB · Views: 0
You must log in or register to reply here.
Back
Top