Obs/ cummins puller chassis/motor
Ford OBS pulling chassis, stripped down, hand throttle for ppump, solid rear, 17-145 welded rear axle. Ford dana 60 front. Dually setup with inner real wheels and aluminum outers/fronts with 315/75/16 tires. Engine bay is setup for cummins engine.
Nv4500 trans, triple disk weighted pulling clutch, 271 t-case.
Motor is a fully built 12v. All new parts with one run. Filled block, machined for all cam bearings, one off girdle supports. Has gorilla girdle/14mm mains. Carrillo rods, Ross pistons, gapless rings. Schied billet cam, all new tappets. Roller rockers, arp head studs, o-ring groves in block. Hamilton race head ported and polished, bigger valves, hardend seats bronze guides. Full waterman fuel setup with 13mm ppump. Joker intake, steep speed t6 comp exh. Freshly rebuilt hx-60 3.0sb.
Only bad is on a test launch something popped and motor is hard to turn over but does turn over. now.. asking $25k for everything. Make offer on separating though.
Located upstate central NY.
__________________
96 fummins 12V puller, few other goodies
BUILT NOT BOUGHT!!!! to
|