RacinDuallie
Black Sheep Racing
True. I was wondering WTF?
Wondering what Weston has to say. op:
True. I was wondering WTF?
Wondering what Weston has to say. op:
There was no direct contact made to me about this until I saw the thread, I reached out to Wayne about said issue. He refused to send the injectors back to me for inspection, even though I offered to replace the injector with whatever he deemed necessary to warrant his needs.
Seth had previously inspected them and I contacted him to discuss, I don't see either of our opinions being held to much of a standard based on the title of this thread. I have a long standing reputation of which I do not take claims like this lightly, but there is only so much I can do when the customer refuses to cooperate, and only wants to hear answers that align with the opinion he has already formed.
I should add, I no longer have any interest in arguing with people on this forum. My offer to help right the situation in any way I can stands.
A 370 Marine injector sprays on the outside of stock cummins bowl , and thousands of them have been ran with no damage.. I realize most dont remember those days..
13mm yada yada, what turbo setup, ptw clearance, wrong end gap, oh and i would like to see what those squirters under the pistons look like..Akerdiesel,
It's nice that chime in without knowing everything involved. But I forget you know everything about my motor------13mm pump, 5 x 18 with lift should wet your appetite. I'll await an independent analysis of my injectors before I finish this event.Did you bother to look at the cylinder? Can you tell me what happened thru your crystal ball?
WAYNES WORLD
Weston NEVER asked me to replace my defective injectors! Yes he talked in PM's, and I listened but thats where it ends.
Akerdiesel,
It's nice that chime in without knowing everything involved. But I forget you know everything about my motor------13mm pump, 5 x 18 with lift should wet your appetite. I'll await an independent analysis of my injectors before I finish this event.Did you bother to look at the cylinder? Can you tell me what happened thru your crystal ball?
WAYNES WORLD
Guys,
Weston made my last set of injectors which were drilled at the wrong angle !This is the second motor destroyed by the wrong spray pattern. Those injectors sprayed outside the bowl. This time I have a 4 x 4 hole in the block. Thus, I will be buying elsewhere-------Thanks but No Thanks.
I'll talk with Infinite Performance.
WAYNES WORLD
This right here.What did the other 5 cylinders look like. If it was incorrect spray angle the other 5 will tell the tail. If it's wrong timing they will show it as well. Judging by the white haze your timing isn't at 24*. My puller at 40* and 5x25's doesn't haze that bad.