JQmile
Comp Diesel Sponsor
Selling two different setups that I was going to use when I was thinking of compounding my Cummins with a blower.
1.First setup is an Eaton M112, race pulley, and balancer drilled to mount on the water pump so that the blower is basically double overdriven. As far as I know the blower works, bought it off a member a while back. $500 obo
2.Second setup is an F2 Procharger display model (no guts: shaft, or compressor wheel) and a cog setup including a "Ferris Wheel" crank pulley that's been drilled for a Cummins dampener. Have the dampener too. $500 obo
If they don't sell after a few weeks or so I'll probably part the stuff out on eBay, just figured I would give guys here a first shot because they're sorta kinda a start to a Cummins setup. Both setups will still need mounting plates, belts, etc. They're also heavy, so probably $50-$100 to ship depending on where you are. Buyer pays shipping. Thanks!
1.First setup is an Eaton M112, race pulley, and balancer drilled to mount on the water pump so that the blower is basically double overdriven. As far as I know the blower works, bought it off a member a while back. $500 obo
2.Second setup is an F2 Procharger display model (no guts: shaft, or compressor wheel) and a cog setup including a "Ferris Wheel" crank pulley that's been drilled for a Cummins dampener. Have the dampener too. $500 obo
If they don't sell after a few weeks or so I'll probably part the stuff out on eBay, just figured I would give guys here a first shot because they're sorta kinda a start to a Cummins setup. Both setups will still need mounting plates, belts, etc. They're also heavy, so probably $50-$100 to ship depending on where you are. Buyer pays shipping. Thanks!