EFI
- Thread starter IdahoRob
- Start date
IdahoRob
Comp Diesel Sponsor
Things are progressing fast now. This quote from EFI crew on what we have to date;
Hi All,
Well the good news is the testers are ready to move on to phase two of the beta program. This will involve tuning the trucks
The first phase of the beta involved reading the ECM calibrations out and then reflashing the unmodified tunes back in. There was a couple of teething problems with a module on the CAN bus causing some grief but that was sorted out pretty fast.
The feedback we have from on truck reading / flashing is as follows.
•No fuse removal required.
•No DTC's set.
•No VIN cleared.
•No double key off/on at end of flash.
•Interrupted reflash full recovery ok.
ECM Read Time: 4:30
ECM Flash Time: 5:30
These times are a typical average, it does vary by maybe 10 - 20 seconds depending on the operating system in the truck, all the test trucks are of course 2006-2007's.
All good news so far!
Cheers,
Ross
Hi All,
Well the good news is the testers are ready to move on to phase two of the beta program. This will involve tuning the trucks
The first phase of the beta involved reading the ECM calibrations out and then reflashing the unmodified tunes back in. There was a couple of teething problems with a module on the CAN bus causing some grief but that was sorted out pretty fast.
The feedback we have from on truck reading / flashing is as follows.
•No fuse removal required.
•No DTC's set.
•No VIN cleared.
•No double key off/on at end of flash.
•Interrupted reflash full recovery ok.
ECM Read Time: 4:30
ECM Flash Time: 5:30
These times are a typical average, it does vary by maybe 10 - 20 seconds depending on the operating system in the truck, all the test trucks are of course 2006-2007's.
All good news so far!
Cheers,
Ross
chizwizdiz
Master Lurker
Great news! It's good to see some advancement in the beta process.