6.7 Stuff

Many miscellaneous 6.7 Cummins parts off a 2008 Rear Geartrain engine. Below are parts that will work on a Dodge 6.7 Cummins:

Cylinder head $500
Rockers & pedistals w. plastic tip $50
Valve bridges $25
Connector tubes $40
Valve cover riser $40
Lower valve cover $50
Upper Valve cover (just says "Cummins") $50
Pushrods $20
Fuel rail and line assy with sensor $200
Injector wire harness $40
ECM mount $40

These are some items listed that are specific to the rear geartrain medium duty applications (such as freightliner, f650, etc)

CP3 $100
front timing cover $20
Rear timing housing w. SAE bellhousing $100
Fuel supply lines (plastic) $5/ea
Cp3 to rail line $10
Harmonic balancer (6 bolt) $50
Crankshaft- needs to be turned $50
Camshaft and gear $50
Water pump $10
Fan hub electric clutch $50

Misc lines and brackets or anything else in pics make an offer.

Also have Allison 2000 trans from a 2008 school bus. Looking for $500 obo on that. Located in northwest CT near the NY and MA border.

Deal pending on upper valve cover.
Riser sold.

Is the fan hub 6.7 universal?

blackmega3500 said:

Is the fan hub 6.7 universal?

Click to expand...

If you PM me your phone number or email address I can text pics. Its not the same as a dodge one and has an electric clutch on it that looks like an AC compressor. Pretty neat setup but not sure if it'd work on a Dodge

I’ll take the rail, lines and sensor. Sending pm

Connector tubes sold