cmns2500
24/2 valves
So, I've been working on a 06 6.0 F450 5r110 to 12 valve/5r110 for three months now (work 4 days as something else, 4 days in the shop) finally, at long last, i have everything figured, down pat, including exhaust... but...
the damned thing won't shift from first... been in contact with DCS, sent them a data log, turns out my TSS ain't reading... great, look up and find what pin goes from it to pcm, all ohm great (.4 ohms from pcm to TSS plug on all four wires), then went to checking key on voltage
have battery voltage on pin one (reference), which is what it should be... pin 3(intermediate speed sensor) has no volts, pin 4(turbine speed sensor) shows 5
anyway, my question to y'all is simple... what voltage should i see key on at pins 3 and 4 on the turbine/intermediate speed sensor connector on an 06 5r110
I've searched and searched and ain't seen a clear answer... all I've seen is battery voltage on 1, and a ground at 2... nothing else
thanks for any help
and I'll post some pictures after someone gives me an answer haha
the damned thing won't shift from first... been in contact with DCS, sent them a data log, turns out my TSS ain't reading... great, look up and find what pin goes from it to pcm, all ohm great (.4 ohms from pcm to TSS plug on all four wires), then went to checking key on voltage
have battery voltage on pin one (reference), which is what it should be... pin 3(intermediate speed sensor) has no volts, pin 4(turbine speed sensor) shows 5
anyway, my question to y'all is simple... what voltage should i see key on at pins 3 and 4 on the turbine/intermediate speed sensor connector on an 06 5r110
I've searched and searched and ain't seen a clear answer... all I've seen is battery voltage on 1, and a ground at 2... nothing else
thanks for any help
and I'll post some pictures after someone gives me an answer haha
Last edited: