NV5600 SB Triple Questions

Smoke'm

Smoke'm

New member
Hey guys I'm pretty new to the sled pulling world and I have a few clutch questions.

I have an 02 Dodge 2500 6 speed. I found a good deal on Southbend triple disc clutch that was behind a NV4500. He ran a bell housing spacer and a 1 3/8 input. If I'm not mistaken my NV5600 is stock with a 1 3/8 shaft but I'm wondering if I would have to run a spacer or is the NV5600 bell housing already deep enough.

Thanks in advance,
Paul
 
bellhousing spacer, or spacer for the starter? the 5600 clutches run a starter spacer and the nv4500 doesn't. running that clutch with an nv4500 requires the starter spacer unless the flywheel was setup special for the nv4500.
 
South bend requires the spacer and a longer input shaft which I’m not sure if you can get for the 5600


Sent from my iPhone using Tapatalk
 
You must log in or register to reply here.
Back
Top