OTC ball joint press

M

muz

New member
Can anyone give me the part number for the OTC press that will work on 2gen rams with dana 60's?
 
MUZ, is this just a once or twice used tool? Or do you plan to crank these BJ's out and make some money? The problem with the OTC style kits, is you need 6 pairs of hands to hold all the adapters. The Snap-On BJP1 all locks together. It's a ton more money, but you'll pound them in and out like no tomorrow with it. It also has a flat spot to put in a vice to bring your work piece to the bench.

https://store.snapon.com/Ball-Joint-Presses-Set-Master-Ball-Joint-Universal-Joint-Press-22pc-P644058.aspx
 
LORDDiESEL said:
MUZ, is this just a once or twice used tool? Or do you plan to crank these BJ's out and make some money? The problem with the OTC style kits, is you need 6 pairs of hands to hold all the adapters. The Snap-On BJP1 all locks together. It's a ton more money, but you'll pound them in and out like no tomorrow with it. It also has a flat spot to put in a vice to bring your work piece to the bench.

https://store.snapon.com/Ball-Joint...Joint-Universal-Joint-Press-22pc-P644058.aspx
Click to expand...



I agree! The snap-on press is the sh*t, hands down but does cost a good coin.
 
It's not going to get a huge amount of use, the Snap on kit here comes in at $920... Do any of you guys know the part number of the Snap on adaptors I would need to do just the ball joints? as buying the frame and just the adaptors I need would be affordable for me
 
You must log in or register to reply here.
Back
Top