jhastings
New member
I'm getting ready to start this motor for the first time and break it in, but had a couple questions. For background this motor has a medium lift cam and 60# valve springs (150# nose pressure).
Was planning on using SAE30 Brad Penn. Will this work?
To start, I was thinking of just cranking with injector lines cracked until good oil pressure.
Once started run at 2k rpm for 20 min?
After that let cool and retourque studs?
Thanks
Sent from my iPhone using Tapatalk
Was planning on using SAE30 Brad Penn. Will this work?
To start, I was thinking of just cranking with injector lines cracked until good oil pressure.
Once started run at 2k rpm for 20 min?
After that let cool and retourque studs?
Thanks
Sent from my iPhone using Tapatalk