WTB: Dodge Dana60 front axle tube ends

I want to buy front axle tube ends (cut) for '00 to '02 Dodge Ram 2500/3500 4wd .

This is the part : looks like big C from side,its welded to axle tubes, ball joints are pressed in and steering knucke are mounted to it.

What is correct name for this part?

The parts must have from '00 to '02 front axle,

'94 to 99 are different because ball joints are pressed to steering knuckle, not to tube end like in 00 to 02 axles.

Any ideas where I can buy those parts? Spicer?



Margus/AsTroSS

The correct part name is (I found 3 different names) :
1. inner knuckle,
2 C
3 end forging

And here is picture:

What are you going to be using the axle for?? If want some SWEET ones and want to switch to a Kingpin style check these guys out http://www.dedenbear.com/TXToffroad.htm#innerC They make them for hardcore rock crawling.

I need '00-'02 inner knuckles, because I want to upgrade my 98 single piston brakes brakes to '02 dual piston brake calipers.

I tought '00-02 outer knuckles with hubs,and brakes will just bolt on to my '98 axle, but they do not fit.

I had '01 axles under my 98. I can't say the braking was improved enough to make it worth the effort you're about to put forth