So, I had some parts fall into my lap so I put a p pump on a 6.7 out of a 2018 ram 2500. Currently it runs great, on my engine stand but thats no fun! I wanna stick it in a 3rd Gen 1500 or 2500 so I can go fool around with it. I live in Wisconsin where everything is rusted beyond (logical) repair and I go to texas fairly often where 3rd Gens with bad motors can be had for 1k-1500 so once I'm done playing with it I can sell the bed for a grand, doors 250 each, etc etc and make my money back on the chassis. Question I have, are the motor mounts on the frame the same from gas to diesel in the 2500s? Same on 1500s? I would assume they are, but I see people building mounts, building plates to move the stock motor mounts, etc. I assume that's Maybe because they are using 12 valves without the optional bosses in the block. Swaps are not new to me, I've done 2 super duty cummins, a 2nd gen half ton, and a 2nd gen 2500 gas to diesel swap, just don't have a 3rd Gen frame around to measure or play with. Thanks for any help!