One of these days I am going to start cutting compressor and turbine housings. Does anyone have any low tech tricks for measuring the inducer to exducer curve on compressor and turbine wheels? it would be sweet if it was some type of equation but I doubt it's that easy.
compressor profile
- Thread starter megastang
- Start date
biggy238
Active member
- Joined
- Aug 3, 2008
- Messages
- 10,959
Would be good to know. I think the shop I used had some sort of comparator they used but that's been several years ago.
Sent from my motorola one 5G using Tapatalk
cetaneaddict
Causing my own headaches
- Joined
- Aug 2, 2012
- Messages
- 1,279
a comparator with radius overlay would be the best/cheapest option.