5.9 or 6.4 stroker

2

2004cuminz

New member
Joined
Dec 6, 2018
Messages
165
Im looking for something that will handle 1250on fuel and 1500 on nos will a 5.9 block on a single handle it or should i just go with a sleeved 6.7 and make a 6.4
 
5.9 with nos at that power likely won’t last .. Hamilton has options in blocks
 
Most of theres are a 6.7 block from what ive seen.i need to find someone who can tell me how to do a sleeved 6.4
 
Neither a 5.9 or 6.7 block would handle that imo. Not reliably. I mean nothing is real reliable at that level but you know what i mean. Fleece/freedom has been doing the 6.4 for awhile
 
Agreed 6.7 isn’t a good option either Hamilton block or going with 6.4 I seen a lot of variables some not lasting .If cost isn’t the factor deck plate it
 
Good do they take 1 inch longer rods. Would be cheaper to go that route than a sleeved down 6.7
 
Deck the block .080 or use .080 rods or have custom pistons made . Using a 6.7 crank and Hamilton 6.7 block with a 5.9 piston will get u close
 
Last edited:
If i used a hamilton block and wanted standard rods would i just use a 6.7 crank or is this a bad idea
 
You must log in or register to reply here.
Back
Top